From samples to supply
A five-step programme that ends in a decision. We generate the data on your bench, at your operating conditions, with our engineers alongside yours.
Five steps, each with a clear outcome
- 01
Technical exchange
NDA, the full datasheet and test conditions, and a test protocol agreed for your stack.
- 02
Samples
A4 sheets in about two weeks; your sizes on request. Each with a certificate of analysis.
- 03
Cell & short-stack tests
Performance, gas purity and durability measured on your bench at your conditions.
- 04
Pilot supply
Pilot quantities in your production format, with full lot traceability.
- 05
Design-in & supply agreement
Vendor registration, quality plan and a supply agreement with on-site support.
- Samples, the datasheet and our test conditions
- A proposed test protocol and reporting template
- Engineers for set-up, testing and analysis, on site within 48 hours
- A certificate of analysis and lot traceability for every sample and roll
- Formats cut to your cell design
- Your operating window: temperature, pressure, KOH concentration and current density
- A reference separator run on the same rig, for a fair comparison
- A named engineer and an agreed test duration
- Shared results, so we can improve the next batch for you
- A decision at the end of each step
Your bench, your numbers
Our headline data was measured at IIT Bombay against a commercial reference on the same rig. Long-duration durability and quantitative gas crossover depend on each stack's operating conditions, so we generate them on the customer's own bench, followed by independent third-party testing.
We would rather show you numbers from your bench than from ours.
Polarisation
Current vs voltage at your temperature and KOH concentration.
Gas purity
H₂-in-O₂ and O₂-in-H₂ across your load range.
Durability
Voltage stability over long-duration operation.
Mechanical
Handling, compression and assembly in your cell frames.
A quality system built for audit
Every roll carries a lot number, release test results and a certificate of analysis you can verify online.
ISO 9001
Our quality management system is being certified to ISO 9001.
Certificate of analysis
Test values, methods, specification and sign-off for every roll.
±5% batch consistency
Key properties held within ±5% from batch to batch.
Start with samples
Tell us your stack and operating window. We'll propose the protocol.